# ============================================================
Change in Falcon - V3.25 - 11/05/2012
# ------------------------------------------------------------

*Lock out changes to rectification and reject when TCG is on for products with suppressive reject (Sitescan)
*Fixed bug where thickness logs were storing probe zero as 0.00us

# ============================================================
Change in Falcon - V3.24 - 01/02/2012
# ------------------------------------------------------------

*Added RF mode when TCG enabled
*Changed brightness controls to being DAC voltage within display spec.

# ============================================================
Change in Falcon - V3.23 - 12/10/2011
# ------------------------------------------------------------

*Calibration function for TX time constant -adjustment too slow
*Testdev required on test and cal "golden sets" - internal release only.

# ============================================================
Change in Falcon - V3.22 - 08/06/2011
# ------------------------------------------------------------

* Fixed bugs in AVG calculations that occasionally caused reboot when changing units
* Fixed bugs that caused reboot when changing to full-screen with DAC on

# ============================================================
Change in Falcon - V3.21 - 11/02/2011
# ------------------------------------------------------------

* Fixed minor bug in TCG test on ATE for SS250's

# ============================================================
Change in Falcon - V3.20 - 11/02/2011
# ------------------------------------------------------------

* changed Flash Chip ID check to cope with new manufacturer

* Added persistence mode, requires FPGA 0x18 (24 decimal)

* Added TX Power control algorithm for Version 4 Analogue board

* Added external trigger capability to MS380

* Fixed height mode bug for SDMS3

# ============================================================
Change in Falcon - V3.17 - 09/06/2010 (Includes Sitescan and Powerscan Models)
# ------------------------------------------------------------

* Fixed T-min was not being cleared when thickness logs were stored.

* Fixed reading were not updated after T-min was cleared, (in Flank mode only).